POWER DOOR LOCK CONTROL SYSTEM All Doors LOCK/UNLOCK Functions do not Operate Via Door Control Switch

DESCRIPTION

The main body ECU (multiplex network body ECU) receives switch signals from the door control switch assembly on the front passenger door and activates the door lock motor on each door according to these signals.

WIRING DIAGRAM

A0004YUE30

CAUTION / NOTICE / HINT

Note

If the main body ECU (multiplex network body ECU) is replaced, refer to Service Bulletin.

PROCEDURE


  1. READ VALUE USING GTS (DOOR CONTROL SWITCH ASSEMBLY)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Main Body / Data List.

    5. Read the Data List according to the display on the GTS.

      Main Body
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Door Lock SW-Lock Door control switch assembly lock signal / ON or OFF

      ON: Lock side of door control switch assembly pushed

      OFF: Lock side of door control switch assembly not pushed

      		 -
      Door Lock SW-Unlock Door control switch assembly unlock signal / ON or OFF

      ON: Unlock side of door control switch assembly pushed

      OFF: Unlock side of door control switch assembly not pushed

      		 -
      OK
      The GTS indicates ON or OFF according to the switch operation shown in the table.

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

    NG

  2. INSPECT DOOR CONTROL SWITCH ASSEMBLY


    1. A00061ME01
      Text in Illustration
      *a

      Component without harness connected

      (Door Control Switch assembly)
      *b Unlock
      *c Lock

      Remove the door control switch assembly Click here.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      4 (L) - 3 (E) Locked Below 1 Ω
      4 (L) - 3 (E) off 10 kΩ or higher
      2 (UL) - 3 (E) Unlocked Below 1 Ω
      2 (UL) - 3 (E) off 10 kΩ or higher

    NG

    REPLACE DOOR CONTROL SWITCH ASSEMBLY Click here

    OK

  3. CHECK HARNESS AND CONNECTOR (DOOR CONTROL SWITCH ASSEMBLY - MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))


    1. Disconnect the H10 main body ECU (multiplex network body ECU) connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      L5-2 (UL) - H10-10 (UL1) Always Below 1 Ω
      L5-4 (L) - H10-9 (L1) Always Below 1 Ω
      L5-3 (E) - Body ground Always Below 1 Ω
      L5-2 (UL) - Body ground Always 10 kΩ or higher
      L5-4 (L) - Body ground Always 10 kΩ or higher

    OK

    REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR