CAN COMMUNICATION SYSTEM(w/ Central Gateway ECU) DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the Power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Central Gateway / Data List.

    5. According to the display on the tester, read the Data List.

      Central Gateway
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      IG2 SW Power switch ON (IG) signal (IG2 terminal) / OFF or ON

      OFF: Power switch ACC or off

      ON: Power switch ON (IG)

      		 -
      IG1 SW Power switch ON (IG) signal (IG1 terminal) / OFF or ON

      OFF: Power switch ACC or off

      ON: Power switch ON (IG)

      		 -
      ACC SW Power switch ACC signal (ACC terminal) / OFF or ON

      OFF: Power switch off

      ON: Power switch ACC or ON (IG)

      		 -
      +B Voltage Battery voltage (BATT terminal) / Over 8 V or Under 8 V

      Over 8 V: Battery voltage 8 V or higher

      Under 8 V: Battery voltage below 8 V

      		 -