ULTRASONIC SENSOR(for Rear Side) INSTALLATION

PROCEDURE

1. INSTALL NO. 1 ULTRASONIC SENSOR

2. INSTALL ULTRASONIC SENSOR CLIP

   
   

   1. Engage the claw to install the ultrasonic sensor clip.

      Tech Tips

      Use the same procedure for all ultrasonic sensor clips.

3. INSTALL NO. 1 ULTRASONIC SENSOR RETAINER

   Tech Tips

   
   

   • Perform this step only when necessary.

   • If a No. 1 ultrasonic sensor retainer has been removed, install a new one and the ultrasonic sensor with clip as a set to the rear bumper assembly.

   • Use the same procedure for all No. 1 ultrasonic sensor retainer.

   
   

   1. 

      Engage the 2 claws and install a new No. 1 ultrasonic sensor retainer to the ultrasonic sensor with clip.

   2. 

      Text in Illustration

      *A	Corner LH Side
      *B	Other Side
      *1	Installation area

      Using a brush or felt, apply primer or equivalent to the No. 1 ultrasonic sensor retainer installation area.

      Note

      
      

      • Use a clean brush or felt.

      • Do not touch the rear bumper assembly until the primer has dried.

   3. Peel off the release paper from the new No. 1 ultrasonic sensor retainer.

   4. 

      Text in Illustration

      *A	Corner LH Side
      *B	Other Side

      Press on the areas indicated by the arrows in the illustration to install the No. 1 ultrasonic sensor retainer and the ultrasonic sensor with clip as a set.

      Note

      Do not damage the rear bumper assembly with the protrusion when installing the retainer.

      Tech Tips

      Stick the new No. 1 ultrasonic sensor retainer on the line marked on the rear bumper assembly.

4. INSTALL ULTRASONIC SENSOR WITH CLIP

   
   
   1. 

      Text in Illustration

      *A	Corner LH Side
      *B	Other Side

      Engage the 2 claws to install the ultrasonic sensor with clip.

   2. 

      Text in Illustration

      *A	Corner LH Side
      *B	Other Side

      Engage the clamp and connect the connector.

5. INSTALL REAR BUMPER ASSEMBLY

   Click here