CLEARANCE WARNING BUZZER REMOVAL

Click here

PROCEDURE

1. Click here

   PRECAUTION (for Multi-Media Module Receiver Type)

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (Click here).

2. Click here

   CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

   Click here

3. Click here

   REMOVE LUGGAGE TRIM SERVICE HOLE COVER (for Multi-Media Module Receiver Type)

   Click here

4. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (for Multi-Media Module Receiver Type)

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

5. Click here

   REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

6. Click here

   REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

7. Click here

   REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

8. Click here

   REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

9. Click here

   REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

   Click here

10. Click here

    REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET (for Multi-Media Module Receiver Type)

    Click here

11. Click here

    REMOVE NO. 1 CLEARANCE WARNING BUZZER

    
    

    1. for LHD:

       
       
       1. 

          Disconnect the connector.

       2. Disengage the clamp and remove the No. 1 clearance warning buzzer.

    2. for RHD:

       
       
       1. 

          Disconnect the connector.

       2. Disengage the clamp and remove the No. 1 clearance warning buzzer.