Click here

BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:C1AB1

Click here
Click here
DTC Code DTC Name
C1AB1 Short to +B in Outer Mirror Indicator(Slave)
Click here

DESCRIPTION

This DTC is stored when the blind spot monitor sensor RH detects a +B short in the outer rear view mirror indicator RH.

DTC No. DTC Detection Condition Trouble Area
C1AB1
  • Both of the following conditions are met:

  • Blind spot monitor main switch (warning canceling switch assembly) is on.


  • The blind spot monitor sensor is not sending voltage to the indicator but the indicator receives voltage above a specified level for a specified period of time.

  • Outer rear view mirror RH (outer rear view mirror indicator RH)

  • Outer rear view mirror assembly RH

  • Wire harness or connector

  • Blind spot monitor sensor RH

  • Outer mirror control ECU assembly RH
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

Click here

PROCEDURE


  1. Click here

    CHECK DTC


    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same DTC is output again.

      OK
      No DTCs are output.

  2. Click here

    CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR RH)


    1. Disconnect the U9 blind spot monitor sensor RH connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      U9-4 (OMIR) - Body ground Power switch on (IG) Below 1 V

  3. Click here

    CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER REAR VIEW MIRROR ASSEMBLY RH)


    1. Disconnect the IND1 outer rear view mirror RH connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      U9-4 (OMIR) - Body ground Power switch on (IG) Below 1 V

  4. Click here

    CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER MIRROR CONTROL ECU ASSEMBLY RH)


    1. Disconnect the z11 outer mirror control ECU assembly RH connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      U9-4 (OMIR) - Body ground Power switch on (IG) Below 1 V

  5. Click here

    CHECK HARNESS AND CONNECTOR (BLIND SPOT MONITOR SENSOR RH - OUTER MIRROR CONTROL ECU ASSEMBLY RH)


    1. Disconnect the L10 outer mirror control ECU assembly RH connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      U9-4 (OMIR) - Body ground Power switch on (IG) Below 1 V

    • OK

      REPLACE OUTER MIRROR CONTROL ECU ASSEMBLY RH (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR