Click here

BLIND SPOT MONITOR SYSTEM, Diagnostic DTC:U1331

Click here
Click here
DTC Code DTC Name
U1331 Software Incompatibility with Body Control Module "B"
Click here

DESCRIPTION

This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors.

DTC No. DTC Detection Condition Trouble Area
U1331 Destination information of the main body ECU (multiplex network body ECU) and blind spot monitor sensor do not match.

  • Main body ECU (multiplex network body ECU)

  • Blind spot monitor sensor LH

  • Blind spot monitor sensor RH
Click here

CAUTION / NOTICE / HINT

Note:

  • When checking for DTCs, make sure that the blind spot monitor main switch (warning canceling switch assembly) is on.

  • When replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.

Click here

PROCEDURE


  1. Click here

    CONFIRM PART NUMBER (MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU))


    1. Check the main body ECU (multiplex network body ECU) part number.


      1. Check if the part number of the main body ECU (multiplex network body ECU) installed on the vehicle is correct.

        OK
        The part number is correct.

  2. Click here

    CHECK DTC


    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same DTC is output again.

      Result
      Result Proceed to
      No DTC is output A
      DTC is output from the blind spot monitor sensor LH (Master) B
      DTC is output from the blind spot monitor sensor RH (Slave) C