Click here

PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) Guide Lines are Displayed with Vehicle Center Line

Click here
Click here
DTC Code DTC Name
  Guide Lines are Displayed with Vehicle Center Line
Click here

DESCRIPTION

The rear television camera assembly can create parking guide lines. Since this function is not necessary on vehicles with the parking assist monitor system, the guide line creation function of the rear television camera assembly is disabled.

Table 1. *a Rear Television Camera Assembly
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • When "System initializing" is displayed on the multi-display assembly after disconnecting the cable from the negative (-) auxiliary battery terminal, correct the steering angle neutral point (Click here).

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed (Click here).

Click here

PROCEDURE


  1. Click here

    CHECK SCREEN MODE


    1. A0008FSE01

      Check the back guide monitor screen.

      Result
      Result Proceed to
      Guide lines are displayed with vehicle center line. A
      Guide lines are displayed without vehicle center line. B
      Table 2. Text in Illustration
      *a Vehicle Center Line

  2. Click here

    CHECK HARNESS AND CONNECTOR (REAR TELEVISION CAMERA ASSEMBLY - BODY GROUND)


    1. Disconnect the U6 rear television camera assembly connector.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        U6-1 (CURT) - Body ground Always Below 1 Ω

    • OK

      REPLACE REAR TELEVISION CAMERA ASSEMBLY (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR