DATA LIST
Note
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tech Tips
Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Chassis / Advanced Parking Guidance/Parking Assist Monitor / Data List.
Read the Data List according to the display on the GTS.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Destination Data Check | Verification of destination data/OK or NG | OK: Data verification normal NG: Data verification abnormal |
- |
| EEPROM Status (Initial read) | Rear television camera assembly information/OK or NG | OK: Rear television camera assembly normal NG: Rear television camera assembly abnormal |
- |
| CPU Communication Status | Rear television camera assembly information/OK or NG | OK: Rear television camera assembly normal NG: Rear television camera assembly abnormal |
- |
| ASIC Output Status | Output condition of video signal/OK or NG | OK: Output condition of video signal normal NG: Output condition of video signal abnormal |
- |
| Wheel Speed Sensor (4wheel) | Vehicle speed signal from speed sensor/OK or NG | OK: Speed signal normal NG: Speed signal abnormal |
- |
| Parking Assist Function of Camera | Rear television camera assembly condition/Valid or Invalid | Valid: Rear television camera assembly operating Invalid: Rear television camera assembly not operating |
- |
| Number of DTC | Number of stored trouble codes/min.: 0, max.: 255 | Number of DTCs will be displayed | - |