PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) HOW TO PROCEED WITH TROUBLESHOOTING

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tech Tips


  • Use the following procedure to troubleshoot the parking assist monitor system.

  • *: Use the GTS.

PROCEDURE


  1. VEHICLE BROUGHT TO WORKSHOP

    Result
    Proceed to
    NEXT

    NEXT

  2. INSPECT AUXILIARY BATTERY VOLTAGE


    1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM


    1. Refer to the navigation system Click here.

      Result
      Result Proceed to
      Navigation system is normal A
      Navigation system is abnormal B

    B

    GO TO NAVIGATION SYSTEM Click here

    A

  4. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*


    1. Use the GTS to check if the CAN communication system is functioning normally Click here.

      Result
      Result Proceed to
      CAN DTCs are not output. (w/ Power Trunk Lid System) A
      CAN DTCs are not output. (w/o Power Trunk Lid System) B
      CAN DTCs are output. C

    B

    GO TO STEP 6 Click here

    C

    GO TO CAN COMMUNICATION SYSTEM Click here

    A

  5. CHECK FOR DTC (LUGGAGE COMPARTMENT DOOR CLOSER SYSTEM)*


    1. Check for DTCs Click here.

      Result
      Result Proceed to
      Luggage compartment door closer system DTCs are not output. A
      Luggage compartment door closer system DTCs are output. B

    B

    GO TO LUGGAGE COMPARTMENT DOOR CLOSER SYSTEM Click here

    A

  6. CHECK FOR DTC (PARKING ASSIST MONITOR SYSTEM)*


    1. Check for DTCs and note any codes that are output Click here.

    2. Clear the DTCs Click here.

    3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Note

      The multi-media module receiver assembly outputs DTCs for the following systems. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant systems.

      System Proceed to
      Navigation System

      Click here

      G-BOOK System

      Click here

      Result
      Result Proceed to
      No DTCs are output. A
      DTCs for parking assist monitor system are output. B
      DTCs for navigation system are output. C
      DTCs for G-BOOK system are output. D

    B

    GO TO STEP 9 Click here

    C

    GO TO NAVIGATION SYSTEM Click here

    D

    GO TO G-BOOK SYSTEM Click here

    A

  7. PROBLEM SYMPTOMS TABLE


    1. Refer to Problem Symptoms Table Click here.

      Result
      Result Proceed to
      Fault is not listed in Problem Symptoms Table A
      Fault is listed in Problem Symptoms Table B

    B

    GO TO STEP 9 Click here

    A

  8. OVERALL ANALYSIS AND TROUBLESHOOTING*


    1. Diagnosis System Click here

    2. Terminals of ECU Click here

    3. Data List / Active Test (See apge Click here)

      Result
      Proceed to
      NEXT

    NEXT

  9. ADJUST, REPAIR OR REPLACE

    Result
    Proceed to
    NEXT

    NEXT

  10. CONFIRMATION TEST

    Result
    Proceed to
    NEXT

    NEXT

    END