PARKING ASSIST MONITOR SYSTEM(w/ Parallel Parking Assist Function) HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   VEHICLE BROUGHT TO WORKSHOP

   Result
   Proceed to NEXT

   
   
   • NEXTClick here
2. Click here

   INSPECT AUXILIARY BATTERY VOLTAGE

   
   

   1. Measure the auxiliary battery voltage with the power switch off.

      Standard Voltage
      11 to 14 V

      If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.

      Result
      Proceed to NEXT

   
   
   • NEXTClick here
3. Click here

   CHECK IF SAME SYMPTOM APPEARS IN OTHER SYSTEM

   
   

   1. Refer to Navigation System (Click here).*1

   2. Refer to Audio and Visual System (w/ Multi-display)(Click here).*2

      *1: w/ Navigation System

      *2: w/o Navigation System

      Result
      Result Proceed to Symptom does not occur A Symptom appears (w/ Navigation System) B Symptom appears (w/o Navigation System) C

   
   
   • AClick here
   • B

     GO TO NAVIGATION SYSTEM (Click here)

   • C

     GO TO AUDIO AND VISUAL SYSTEM (w/ Multi-display) (Click here)

4. Click here

   CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*

   
   

   1. Use the GTS to check if the CAN communication system is functioning normally (Click here).

      Result
      Result Proceed to CAN DTCs are not output. (w/ Power Trunk Lid System) A CAN DTCs are not output. (w/o Power Trunk Lid System) B CAN DTCs are output. C

   
   
   • AClick here
   • BClick here

     GO TO STEP 6

   • C

     GO TO CAN COMMUNICATION SYSTEM (Click here)

5. Click here

   CHECK FOR DTC (LUGGAGE COMPARTMENT DOOR CLOSER SYSTEM)*

   
   

   1. Check for DTCs (Click here).

      Result
      Result Proceed to Luggage compartment door closer system DTCs are not output. A Luggage compartment door closer system DTCs are output. B

   
   
   • AClick here
   • B

     GO TO LUGGAGE COMPARTMENT DOOR CLOSER SYSTEM (Click here)

6. Click here

   CHECK FOR DTC (PARKING ASSIST MONITOR SYSTEM)*

   
   

   1. Check for DTCs and note any codes that are output (Click here).

   2. Clear the DTCs (Click here).

   3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.

      Note:

      The multi-media module receiver assembly outputs DTCs for the following systems. When DTCs other than those in Diagnostic Trouble Code Chart for the parking assist monitor system are output, refer to Diagnostic Trouble Code Chart for the relevant system.

      System	Proceed to
      Navigation System*1	Click here
      Audio and Visual System (w/ Multi-display)* 2	Click here
      G-BOOK System	Click here

      *1: w/ Navigation System

      *2: w/o Navigation System

      Result
      Result Proceed to No DTCs are output. A Parking assist monitor system DTCs are output. B Navigation system DTCs are output (w/ Navigation System) C Audio and visual system (w/ Multi-display) DTCs are output (w/o Navigation System) D DTCs for G-BOOK system are output. E

   
   
   • AClick here
   • BClick here

     GO TO STEP 9

   • C

     GO TO NAVIGATION SYSTEM (Click here)

   • D

     GO TO AUDIO AND VISUAL SYSTEM (w/ Multi-display) (Click here)

   • E

     GO TO G-BOOK SYSTEM (Click here)

7. Click here

   PROBLEM SYMPTOMS TABLE

   
   

   1. Refer to the Problem Symptoms Table (Click here).

      Result
      Result Proceed to Fault is not listed in Problem Symptoms Table A Fault is listed in Problem Symptoms Table B

   
   
   • AClick here
   • BClick here

     GO TO STEP 9

8. Click here

   OVERALL ANALYSIS AND TROUBLESHOOTING*

   
   

   1. Diagnosis System (Click here)

   2. Terminals of ECU (Click here)

   3. Data List / Active Test (See apgeClick here)

      Result
      Proceed to NEXT

   
   
   • NEXTClick here
9. Click here

   ADJUST, REPAIR OR REPLACE

   Result
   Proceed to NEXT

   
   
   • NEXTClick here
10. Click here

    CONFIRMATION TEST

    Result
    Proceed to NEXT

    
    
    • NEXT

      END