FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

PROCEDURE

1. Click here

   INSTALL EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)

   
   
   1. 

      Install the evaporator temperature sensor (No. 1 cooler thermistor) as shown in the illustration.

      Part	Length
      A	34.3 mm	1.35 in.
      B	20.9 mm	0.823 in.
      C	50.0 mm	1.97 in.

      Table 1. Text in Illustration

      *a	Fixed Part
      *b	Sensor Part

      Note:
      

      • Be sure to insert the thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

      • When reusing the evaporator, insert the thermistor one row next to the one that has been used previously (X in the illustration).

      • After inserting the thermistor, do not apply excessive force to the wire.

      • Directly insert the thermistor until the edge of plastic case "a" comes into contact with evaporator "b".

2. Click here

   INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

   Click here

3. Click here

   INSTALL COOLER EXPANSION VALVE

   Click here

4. Click here

   INSTALL HEATER PACKING

   Click here

5. Click here

   INSTALL AIR CONDITIONING HARNESS ASSEMBLY

   Click here

6. Click here

   INSTALL BLOWER ASSEMBLY

   Click here

7. Click here

   INSTALL AIR CONDITIONING UNIT ASSEMBLY

   (Click here)