ROOM TEMPERATURE SENSOR REMOVAL

Click here

PROCEDURE

1. Click here

   PRECAUTION

   Note:

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work (Click here).

2. Click here

   REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. Click here

   DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

4. Click here

   REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

5. Click here

   REMOVE FRONT DOOR SCUFF PLATE LH

   Click here

6. Click here

   REMOVE COWL SIDE TRIM BOARD LH

   Click here

7. Click here

   REMOVE FRONT DOOR OPENING TRIM COVER LH

   Click here

8. Click here

   REMOVE INSTRUMENT SIDE PANEL LH

   Click here

9. Click here

   DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

   Click here

10. Click here

    REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    Click here

11. Click here

    REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

12. Click here

    REMOVE SWITCH BASE

    Click here

13. Click here

    REMOVE COOLER (ROOM TEMP. SENSOR) THERMISTOR

    
    
    1. 

       Disengage the 2 claws.

    2. 

       Disconnect the connector and cooler thermistor hose, and remove the cooler (room temp. sensor) thermistor.