Click here

TELEMATICS SYSTEM, Diagnostic DTC:B15C6

Click here
Click here
DTC Code DTC Name
B15C6 Ignition Switch Signal Malfunction
Click here

DESCRIPTION

If vehicle movement (10 km/h (6 mph) or more for 10 seconds) is detected based on the location data sent from the multi-media module receiver assembly even when the telematics transceiver detects that the power switch is off, this DTC will be stored.

DTC No. DTC Detection Condition Trouble Area
B15C6 IG signal error

  • Wire harness or connector

  • Telematics transceiver
Click here

WIRING DIAGRAM

Click here

CAUTION / NOTICE / HINT

Note:

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for G-BOOK (Click here).

Click here

PROCEDURE


  1. Click here

    CHECK DTC OUTPUT


    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check that no DTCs are output.

      OK
      No DTCs are output.

  2. Click here

    CHECK HARNESS AND CONNECTOR (TELEMATICS TRANSCEIVER POWER SOURCE)


    1. Disconnect the H101 telematics transceiver connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H101-4 (E) - Body ground Always Below 1 Ω

    3. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H101-7 (IG2) - Body ground Power switch on (IG) 11 to 14 V

    • OK

      REPLACE TELEMATICS TRANSCEIVER (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR