HARD DISK DRIVE REMOVAL

PROCEDURE

1. PRECAUTION

   Note

   
   

   • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

   • A Hard Disk Drive (HDD) is built into the multi-media module receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling the multi-media module receiver assembly.

   • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

   Click here

3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

   Click here

6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

8. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

9. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET

   Click here

10. REMOVE NO. 2 RADIO BRACKET

    Click here

11. REMOVE HARD DISK DRIVE

    
    

    1. 

       Remove the 2 screws.

    2. Disengage the 2 guides to remove the cover.

    3. 

       Text in Illustration

       *1	Protective Tape

       Using a screwdriver with its tip wrapped with protective tape, slide the hard disk drive in the direction shown by the arrow to remove it.