Click here

NAVIGATION SYSTEM Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter

Click here
Click here
DTC Code DTC Name
  Data Signal Circuit between Navigation Receiver Assembly and Stereo Jack Adapter
Click here

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the multi-media module receiver assembly via this circuit.

Table 1. *a (Shielded) *b No. 1 Stereo Jack Adapter Assembly *c Multi-media Module Receiver Assembly
Click here

WIRING DIAGRAM

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. A0007SQE02

      Disconnect the H164 multi-media module receiver assembly connector.

    2. Disconnect the H154 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H164-2 (US1-) - H154-2 (UDO-) Always Below 1 Ω
      H164-3 (US1+) - H154-3 (UDO+) Always Below 1 Ω
      H164-5 (USG1) - H154-5 (UJSS) Always Below 1 Ω
      H164-2 (US1-) - Body ground Always 10 kΩ or higher
      H164-3 (US1+) - Body ground Always 10 kΩ or higher
      H164-5 (USG1) - Body ground Always 10 kΩ or higher
      Table 2. Text in Illustration
      *a

      Front view of wire harness connector

      (to Multi-media Module Receiver Assembly)
      *b

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR