NAVIGATION RECEIVER INSTALLATION

PROCEDURE

1. PRECAUTION

   Note

   When installing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

2. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY

3. INSTALL HARD DISK DRIVE

   Click here

4. INSTALL NO. 2 RADIO BRACKET

   
   

   1. Install the No. 2 radio bracket with the 4 screws.

5. INSTALL NO. 1 RADIO BRACKET

   
   

   1. Install the No. 1 radio bracket with the 4 screws.

6. INSTALL MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET

   
   

   1. Connect each connector.

   2. Engage the 2 clips and 2 claws to the vehicle body to temporarily install the multi-media module receiver assembly with bracket.

   3. Install the multi-media module receiver assembly with bracket with the 4 bolts.

7. INSTALL LOWER CENTER INSTRUMENT PANEL FINISH PANEL

   Click here

8. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click here

9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

   Click here

10. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

12. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

13. INSPECT HARD DISK DRIVE

    Click here

14. PERFORM FOR MULTI-MEDIA MODULE RECEIVER ASSEMBLY INITIALIZATION (w/ Parking Assist Monitor System)

    Tech Tips

    When replacing the multi-media module receiver assembly, perform parking assist monitor system initialization Click here.

15. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

    Click here