NAVIGATION RECEIVER REMOVAL

PROCEDURE


  1. PRECAUTION

    Click here

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

    Note

    w/ G-BOOK System:

    When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

    Click here

  3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  8. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

  9. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET


    1. A00065I

      Remove the 4 bolts.

    2. A0004VM

      Pull the multi-media module receiver assembly with bracket toward the rear of the vehicle and disengage the 2 clips and 2 claws.

    3. Disconnect each connector and remove the multi-media module receiver assembly with bracket.

  10. REMOVE NO. 1 RADIO BRACKET


    1. A0006MN

      Remove the 4 screws and No. 1 radio bracket.

  11. REMOVE NO. 2 RADIO BRACKET


    1. A0005XE

      Remove the 4 screws and No. 2 radio bracket.

  12. REMOVE HARD DISK DRIVE (w/ G-BOOK System)

    Click here

  13. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY