NAVIGATION SYSTEM Switch Operation of Remote Touch not Accepted

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precautions for Navigation System Click here.

PROCEDURE


  1. START DIAGNOSTIC MODE


    1. Activate diagnostic mode and check if the "Service Menu" screen can be displayed Click here.

      OK
      Diagnostic mode can be activated.

    NG

    REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK) Click here

    OK

  2. CHECK PANEL SWITCH (OPERATION CHECK)


    1. A0005ZU

      Enter the "Panel&Steering Switch Check Mode" screen. Refer to Check Panel & Steering Switch in Operation Check Click here.

    2. Operate the abnormal switch and check if the switch status is correctly displayed.

      OK
      The switch status is correctly displayed as operated.

    OK

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

    NG

  3. REMOTE TOUCH SELF CHECK (SWITCH OPERATION CHECK)


    1. Activate self check mode Click here.

    2. A0003F4E01
      Text in Illustration
      *a Switch Illumination
      *b Switch Knob

      Check switch operation.


      1. Move the remote touch switch knob to the lower left.

      2. Check that the "MAP/VOICE"*1 or "HOME"*2 and "MENU" switches illuminate when each switch on the remote touch is pressed.

        Result
        Result Proceed to
        Self check mode cannot be activated. A
        Some switches do not turn on the "MAP/VOICE"*1 or "HOME"*2 and "MENU" switch illumination when they are pressed. A
        All switches turn on the "MAP/VOICE"*1 or "HOME"*2 and "MENU" switch illumination when they are pressed. B

        • *1: w/o Connected Services

        • *2: w/ Connected Services


    B

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

    A

  4. REPLACE REMOTE OPERATION SWITCH


    1. Replace the remote operation switch Click here.

    2. Check that each switch operation on the remote touch is accepted normally.

      OK
      Each switch operation is accepted normally.

    OK

    END

    NG

    REPLACE REMOTE OPERATION BOARD Click here