NAVIGATION SYSTEM Stereo Jack Adapter Light does not Illuminate

DESCRIPTION

Power is supplied to the No. 1 stereo jack adapter assembly illumination from the multi-media module receiver assembly.

WIRING DIAGRAM

A0003Y0E06

CAUTION / NOTICE / HINT

Note

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System Click here.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (NO. 1 STEREO JACK ADAPTER ASSEMBLY ILLUMINATION POWER SOURCE)


    1. Disconnect the H188 and H185 No. 1 stereo jack adapter assembly connectors.

    2. A0009GPE01
      Text in Illustration
      *a

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      H188-1 (USV1) - Body ground Power switch on (ACC) 5 V
      H185-12 (ACC) - Body ground Power switch on (ACC) 11 to 14 V

    OK

    REPLACE NO. 1 STEREO JACK ADAPTER ASSEMBLY Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the H164 multi-media module receiver assembly connector (for LHD).

      Disconnect the H172 multi-media module receiver assembly connector (for RHD).

    2. Disconnect the H188 No. 1 stereo jack adapter assembly connector.

    3. A00063VE02
      Text in Illustration
      *A for LHD
      *B for RHD
      *a

      Front view of wire harness connector

      (to Multi-media Module Receiver Assembly)
      *b

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      for LHD
      Tester Connection Condition Specified Condition
      H188-1 (USV1) - H164-1 (USV1) Always Below 1 Ω
      H188-1 (USV1) - Body ground Always 10 kΩ or higher
      for RHD
      Tester Connection Condition Specified Condition
      H188-1 (USV1) - H172-1 (USV1) Always Below 1 Ω
      H188-1 (USV1) - Body ground Always 10 kΩ or higher

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (MULTI-MEDIA MODULE RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the H94 multi-media module receiver assembly connector.

    2. Disconnect the H185 No. 1 stereo jack adapter assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H94-11 (ACC) - H185-12 (ACC) Always Below 1 Ω
      H94-11 (ACC) - Body ground Always 10 kΩ or higher

    OK

    REPLACE MULTI-MEDIA MODULE RECEIVER ASSEMBLY Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR