NOISE FILTER INSTALLATION

PROCEDURE


  1. INSTALL RADIO SETTING CONDENSER (for Window Defogger)


    1. A0007V5

      Engage the claw to install a new terminal cover to the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

      • Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

      • Do not use excessive force when inserting the wire harness into the terminal cover.

      • If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.

    2. A00055O

      Engage the 3 claws to install the new terminal cover with wire harness to a new condenser.

      Note


      • Do not use excessive force when inserting the terminal cover into the condenser.

      • If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.

    3. Engage the clamp to temporarily install a new radio setting condenser with wire harness.

    4. Install the new radio setting condenser with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  2. INSTALL ROOF SIDE INNER GARNISH ASSEMBLY LH (for Window Defogger)

    Click here

  3. INSTALL RADIO SETTING CONDENSER (for High Mounted Stop Light)


    1. A0008PC

      Engage the claw to install a new terminal cover to the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when installing the wire harness to the terminal cover.

      • Make sure not to bend the exposed wire when installing the wire harness to the terminal cover.

      • Do not use excessive force when inserting the wire harness into the terminal cover.

      • If the terminal cover has been deformed at installation, replace the terminal and terminal cover with new ones.

    2. A0003SI

      Engage the 6 claws to install the 2 new terminal covers with wire harness to a new condenser.

      Note


      • Do not use excessive force when inserting the terminal cover into the condenser.

      • If the terminal cover has been deformed at installation, replace the terminal, terminal cover and condenser with new ones.

    3. A0005LB

      Insert the cover as shown in the illustration and engage the claw.

    4. Engage the clamp to temporarily install a new radio setting condenser with wire harness.

    5. Install the new radio setting condenser with the bolt.

      Torque:
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

  4. INSTALL REAR SEAT SIDE GARNISH LH

    Click here

  5. INSTALL REAR DOOR SCUFF PLATE LH

    Click here

  6. INSTALL REAR SEATBACK ASSEMBLY

    Click here