Click here

NOISE FILTER REMOVAL

Click here
Click here

PROCEDURE


  1. Click here

    REMOVE REAR SEATBACK ASSEMBLY

    (Click here)

  2. Click here

    REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  3. Click here

    REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  4. Click here

    REMOVE RADIO SETTING CONDENSER (for High Mounted Stop Light)

    Note:

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


    1. A00088Y

      Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. A0003X1

      Disengage the claw and pull out the cover as shown in the illustration.

    4. A0005MP

      Using a screwdriver, disengage the 6 claws and remove the 2 terminal covers with wire harness from the condenser.

    5. A0003ZY

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    6. Remove the terminal cover from the wire harness.

      Note:

      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.

  5. Click here

    REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH (for Window Defogger)

    Click here

  6. Click here

    REMOVE RADIO SETTING CONDENSER (for Window Defogger)

    Note:

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


    1. A0007EB

      Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. A0005VV

      Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.

    4. A00073R

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    5. Remove the terminal cover from the wire harness.

      Note:

      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.