Click here

INSTRUMENT PANEL SPEAKER INSPECTION

Click here
Click here

PROCEDURE


  1. Click here

    INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)


    1. With the speaker installed, check that there is no looseness or other abnormalities.

    2. Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.

    3. A0004TBE02

      Measure the resistance of the speaker.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Always 3.2 to 4.8 Ω

      If the result is not as specified, replace the speaker.

      Table 1. Text in Illustration
      *a

      Component without harness connected

      (Front No. 2 Speaker Assembly)
  2. Click here

    INSPECT FRONT NO. 3 SPEAKER ASSEMBLY (for 8 Speakers)


    1. With the speaker installed, check that there is no looseness or other abnormalities.

    2. Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.

    3. A0007NIE27

      Measure the resistance of the speaker.

      Standard Resistance
      Tester Connection Condition Specified Condition
      1 - 2 Always 3.2 to 4.8 Ω

      If the result is not as specified, replace the speaker.

      Table 2. Text in Illustration
      *a

      Component without harness connected

      (Front No. 3 Speaker Assembly)
  3. Click here

    INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (for 15 Speakers)


    1. When there is a possibility that either the right or left speaker is malfunctioning, interchange the speakers and perform an inspection. If the malfunction disappears after interchanging the speakers, replace the malfunctioning speaker.

      Tip:

      Connect all connectors to the speakers when performing an inspection. If the result is not as specified, replace the speaker.

  4. Click here

    INSPECT FRONT NO. 3 SPEAKER ASSEMBLY (for 15 Speakers)


    1. Check that the malfunction disappears when a known good speaker is installed (Click here).

      OK
      Malfunction disappears.
      Tip:

      Connect all the connectors to the rear No. 2 speaker assemblies that were disconnected.