RADIO RECEIVER REMOVAL

PROCEDURE


  1. PRECAUTION (w/ Multi-display)

    Note


    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

    • A Hard Disk Drive (HDD) is built into the multi-media module receiver assembly to store map and other data, and is used for the navigation system. Therefore, make sure to read all of the precautions thoroughly before handling the multi-media module receiver assembly Click here.

    • When removing the hard disk drive, eliminate static electricity by touching the vehicle body to prevent components from being damaged.

  2. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM (for Power Tilt and Power Telescopic Steering Column)

    Click here

  3. REMOVE LUGGAGE TRIM SERVICE HOLE COVER (w/ Multi-display)

    Click here

  4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL (w/ Multi-display)

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  5. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  6. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL GARNISH

    Click here

  7. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

    Click here

  8. REMOVE LOWER CENTER INSTRUMENT PANEL FINISH PANEL

    Click here

  9. REMOVE RADIO RECEIVER ASSEMBLY WITH BRACKET (w/o Multi-display)


    1. A00097W

      Remove the 4 bolts.

    2. A0004DM

      Pull the radio receiver assembly with bracket toward the rear of the vehicle and disengage the 2 clips and 2 claws.

    3. Disconnect each connector and remove the radio receiver assembly with bracket.

  10. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY WITH BRACKET (w/ Multi-display)

    Click here

  11. REMOVE NO. 1 RADIO BRACKET (w/o Multi-display)


    1. A00057U

      Remove the 4 screws and No. 1 radio bracket.

  12. REMOVE NO. 1 RADIO BRACKET (w/ Multi-display)

    Click here

  13. REMOVE NO. 2 RADIO BRACKET (w/o Multi-display)


    1. A0008UY

      Remove the 4 screws and No. 2 radio bracket.

  14. REMOVE NO. 2 RADIO BRACKET (w/ Multi-display)

    Click here

  15. REMOVE HARD DISK DRIVE (w/ Multi-display)

    Click here

  16. REMOVE RADIO RECEIVER ASSEMBLY (w/o Multi-display)

  17. REMOVE MULTI-MEDIA MODULE RECEIVER ASSEMBLY (w/ Multi-display)