AUDIO AND VISUAL SYSTEM(for 8 Speakers) Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the radio receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

A0006PLE16
*a (Shielded)
*b Radio Receiver Assembly
*c Stereo Component Amplifier Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the H180 radio receiver assembly connector.

    2. Disconnect the H87 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester connection Condition Specified condition
      H180-2 (RL+) - H87-15 (II1+) Always Below 1 Ω
      H180-6 (RL-) - H87-14 (II1-) Always Below 1 Ω
      H87-18 (SLD1) - Body ground Always 10 kΩ or higher
      H180-2 (RL+) - Body ground Always 10 kΩ or higher
      H180-6 (RL-) - Body ground Always 10 kΩ or higher

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR