Click here

AUDIO AND VISUAL SYSTEM(for 8 Speakers) Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

Click here
Click here
DTC Code DTC Name
  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter
Click here

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio receiver assembly via this circuit.

Table 1. *a (Shielded) *b No. 1 Stereo Jack Adapter Assembly *c Radio Receiver Assembly *d Data Signal (USB Communication Line)
Click here

WIRING DIAGRAM

Click here

PROCEDURE


  1. Click here

    CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)


    1. Disconnect the H186 radio receiver assembly connector.

    2. Disconnect the H188 No. 1 stereo jack adapter assembly connector.

    3. A0005HCE03

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      H186-2 (US1-) - H188-2 (US1-) Always Below 1 Ω
      H186-3 (US1+) - H188-3 (US1+) Always Below 1 Ω
      H186-5 (USG1) - H188-5 (UJSS) Always Below 1 Ω
      H186-2 (US1-) - Body ground Always 10 kΩ or higher
      H186-3 (US1+) - Body ground Always 10 kΩ or higher
      H186-5 (USG1) - Body ground Always 10 kΩ or higher
      Table 2. Text in Illustration
      *a

      Front view of wire harness connector

      (to Radio Receiver Assembly)
      *b

      Front view of wire harness connector

      (to No. 1 Stereo Jack Adapter Assembly)

    • OK

      PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

    • NG

      REPAIR OR REPLACE HARNESS OR CONNECTOR