STEERING GEAR INSPECTION

Click here Click here

PROCEDURE

1. Click here

   INSPECT TIE ROD ASSEMBLY

   
   
   1. 

      Secure the tie rod assembly in a vise.

      Note:

      Do not overtighten the vise.

   2. Install the nut to the stud bolt.

   3. Flip the ball joint back and forth 5 times.

   4. Set a torque wrench to the nut, turn the ball joint continuously at a rate of 3 to 5 seconds per turn, and check the turning torque on the 5th turn.

      Standard turning torque
      1.0 to 3.9 N*m (10 to 39 kgf*cm, 9 to 34 in.*lbf)

      Tip:

      If the turning torque is not within the specified range, replace the tie rod assembly.

2. Click here

   INSPECT TOTAL PRELOAD

   Note:

   Inspect the total preload in a no-load condition by removing the tie rod assembly RH and LH, and steering rack boots.

   
   
   1. 

      Install SST to the pinion shaft and turn it left and right 5 times or more.

      09616-00020

   2. Set a torque wrench to SST and turn the pinion shaft continuously at a rate of 4 to 6 seconds per turn to inspect the total preload of the steering gear assembly.

      Standard preload
      0.7 to 1.2 N*m (7 to 12 kgf*cm, 6 to 10 in.*lbf)

      Note:

      Inspect the total preload around the steering rack center position.

      Tip:

      If the total preload is not within the specified range, replace the steering gear assembly with a new one.