POWER STEERING SYSTEM DTC CHECK / CLEAR


  1. CHECK DTCs (USING GTS)


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Chassis / EMPS / Trouble Codes.

    6. Check the details of the DTCs Click here.

  2. CHECK DTCs (USING SST CHECK WIRE)


    1. A0008FXE39
      Text in Illustration
      *1 DLC3

      Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040

    2. Turn the power switch on (IG).

    3. A0006WUE02
      Text in Illustration
      *a Normal system code
      *b Codes 21 and 22

      Read and write down any DTCs indicated by the blinking of the EPS warning light on the combination meter assembly. Refer to the illustration to the left for examples of the normal system code and DTCs 21 and 22.

      Tech Tips


      • If the EPS warning light does not blink to display stored DTCs or the normal system code, inspect the circuit shown in the table below.

        Trouble Area See Page
        EPS warning light circuit

        Click here

      • If two or more malfunctions are detected simultaneously, DTCs will be displayed in ascending numerical order.

    4. Refer to the Diagnostic Trouble Code Chart Click here for DTC information.

    5. Check the details of the DTCs.

      EPS DTC
      EPS Warning Light Display Tester Display
      11 C1511
      C1512
      C1513
      C1514
      C1517
      12 C1528
      13 C1541
      15 C1515
      16 C1516
      22 C1552
      23 C1554
      24 C1521
      C1522
      C1523
      C1524
      25 C1531
      C1532
      C1533
      C1534
      C1551
      C1555
      26 C1581
      C1582
      41 U0293
      42 U0129

  3. CLEAR DTCs (USING GTS)


    1. Turn the power switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the power switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Chassis / EMPS / Trouble Codes.

    6. Clear the DTCs.

    7. Turn the power switch off.

    8. Disconnect the GTS from the DLC3.

  4. CLEAR DTCs (USING SST CHECK WIRE)


    1. A0008FXE37
      Text in Illustration
      *1 DLC3

      Using SST, connect terminals 12 (TS) and 4 (CG) of the DLC3, and also terminals 13 (TC) and 4 (CG) of the DLC3.

      SST
      09843-18040

    2. Turn the power switch on (IG).

    3. Disconnect and reconnect terminal 13 (TC) of the DLC3 4 times or more within 8 seconds.

    4. Check that the EPS warning light blinks the normal system code.

    5. Turn the power switch off.

    6. Remove SST from the DLC3.