PARKING BRAKE PEDAL(for LHD) INSTALLATION

PROCEDURE

1. Click here

   INSTALL PARKING BRAKE PEDAL SUB-ASSEMBLY

   
   
   1. 

      Install the parking brake pedal sub-assembly with the bolt and 2 nuts.

      15 N*m

      153 kgf*cm

      11 ft.*lbf

      Note:

      Tighten the bolt and 2 nuts in the order shown in the illustration.

   2. Connect the parking brake switch assembly connector.

   3. Install the No. 1 parking brake cable assembly with the bolt and 2 nuts.

      Bolt
      15 N*m	153 kgf*cm	11 ft.*lbf
      Nut
      5.4 N*m	55 kgf*cm	48 in.*lbf

   4. Install the clip to the No. 1 parking brake cable assembly.

   5. Install the floor carpet.

   6. 

      Temporarily install the lock nut.

      Table 1. Text in Illustration

      *1	Lock Nut
      *2	Adjusting Nut

      Tip:

      After adjusting parking brake pedal travel, tighten the lock nut.

2. Click here

   CONNECT NO. 4 PARKING BRAKE CABLE ASSEMBLY

   
   
   1. 

      Connect the No. 4 parking brake cable assembly to the parking brake pedal sub-assembly as shown in the illustration.

      Table 2. Text in Illustration

      *a	Turn
      *b	Hold

      5.4 N*m

      55 kgf*cm

      48 in.*lbf

3. Click here

   INSTALL POWER MANAGEMENT CONTROL ECU

   Click here

4. Click here

   INSTALL AIRBAG SENSOR ASSEMBLY

   Click here

5. Click here

   INSTALL FLOOR CARPET BRACKET RH

   Click here

6. Click here

   INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

   (Click here)

7. Click here

   INSTALL SHIFT LEVER SUPPORT

   (Click here)

8. Click here

   ADJUST PARKING BRAKE PEDAL TRAVEL

   Click here

9. Click here

   INSPECT BRAKE WARNING LIGHT

   Click here