FRONT BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Because the left and right hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tech Tips


  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT FLEXIBLE HOSE


    1. A0006AEE08
      Text in Illustration
      *1 Clip
      *a Identification Mark

      Install a new clip to the front flexible hose.

      Note


      • Install the clip as far as it will go.

      • When installing the front flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the hose.

    2. Using a union nut wrench, connect the brake line to the front flexible hose while holding the flexible hose with a wrench.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Note


      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

      • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench Click here.

    3. A00066PE04
      Text in Illustration
      *1 Front Speed Sensor Clamp
      *2 Front Flexible Hose
      *3 Claw

      Install the front speed sensor clamp and front flexible hose to the shock absorber bracket with the bolt.

      Torque:
      19 N*m  { 192 kgf*cm, 14 ft.*lbf }

      Note


      • Do not twist the wire harness for the front speed sensor when installing it.

      • Securely set the 2 claws of the front speed sensor clamp to the shock absorber bracket.

      • A bolt tightens the brake flexible hose and front speed sensor together. Make sure that the front flexible hose is positioned over the front speed sensor.

    4. A0008SEE07
      Text in Illustration
      *a Lock Hole

      Connect the front flexible hose to the front disc brake cylinder assembly with a new union bolt and a new gasket.

      Torque:
      29 N*m  { 300 kgf*cm, 22 ft.*lbf }

      Note

      Install the flexible hose lock securely into the lock hole in the front disc brake cylinder.

  2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  3. BLEED BRAKE LINE

    Click here

  4. INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

    Click here

  5. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)

    Tech Tips

    Use the same procedure as for LHD Click here.

  6. INSTALL FRONT WHEEL

    Torque:
    103 N*m  { 1049 kgf*cm, 76 ft.*lbf }