Click here

REAR BRAKE FLEXIBLE HOSE INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Note:

  • Because the left and right rear flexible hoses are not interchangeable, verify the part number when installing the flexible hoses.

  • If the hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

Tip:

  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL REAR FLEXIBLE HOSE


    1. A0004NME09

      Connect the rear flexible hose to the rear disc brake cylinder assembly with a new union bolt and a new gasket.

      33 N*m 340 kgf*cm 25 ft.*lbf
      Table 1. Text in Illustration
      *a Lock Hole
      Note:

      Install the flexible hose lock securely into the lock hole in the disc brake cylinder.

    2. A0004TGE03

      Install a new clip.

      Table 2. Text in Illustration
      *1 Brake Line
      *2 Clip
      *3 Bolt
      *a Identification Mark
      Note:

      • Install the clip as far as it will go.

      • When installing the rear flexible hose, face the identification mark to the outside of the vehicle and minimize twisting of the hose.

    3. Install the rear flexible hose with the bolt.

      19 N*m 192 kgf*cm 14 ft.*lbf

    4. Using a union nut wrench, connect the brake line to the rear flexible hose while holding the rear flexible hose with a wrench.

      15 N*m 155 kgf*cm 11 ft.*lbf
      Note:

      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

      • Use the formula to calculate special torque values for situations where the union nut wrench is combined with a torque wrench (Click here).

  2. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    (Click here)

  3. Click here

    BLEED BRAKE LINE

    Click here

  4. Click here

    INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)

    Click here

  5. Click here

    INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY (for RHD)

    Tip:

    Use the same procedure as for LHD (Click here).

  6. Click here

    INSTALL REAR WHEEL

    103 N*m 1049 kgf*cm 76 ft.*lbf