Click here

REAR BRAKE FLEXIBLE HOSE REMOVAL

Click here
Click here

CAUTION / NOTICE / HINT

Note:

If the left and right hoses are disconnected at the same time, be sure to place a mark on each hose to indicate its installation position.

Tip:

  • Use the same procedure for the LH side and RH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISABLE BRAKE CONTROL

    Click here

  3. Click here

    REMOVE REAR WHEEL

  4. Click here

    DRAIN BRAKE FLUID

    Note:

    If brake fluid leaks onto any painted surface, immediately wash it off.

  5. Click here

    REMOVE REAR FLEXIBLE HOSE


    1. A00045BE06

      Using a union nut wrench, disconnect the brake line while holding the rear flexible hose with a wrench.

      Table 1. Text in Illustration
      *1 Brake Line
      *2 Clip
      *3 Bolt
      Note:

      • Do not bend or damage the brake line.

      • Do not allow any foreign matter such as dirt or dust to enter the brake line from the connecting points.

    2. Remove the clip from the rear flexible hose.

    3. Remove the bolt.

    4. A0004NM

      Remove the union bolt, gasket and rear flexible hose.