REAR STRUT ROD INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   TEMPORARILY TIGHTEN REAR STRUT ROD ASSEMBLY

   
   
   1. 

      Temporarily tighten rear strut rod assembly (rear) with the bolt and nut.

      Note:

      When temporarily tightening the bolt, keep the nut from rotating.

      Tip:

      Insert the bolt from the inside of the vehicle.

   2. Support the rear axle carrier sub-assembly with a jack and a wooden block.

   3. Connect the rear strut rod assembly (front) with the 2 bolts.

2. Click here

   STABILIZE SUSPENSION

   Click here

3. Click here

   FULLY TIGHTEN REAR STRUT ROD ASSEMBLY

   
   

   1. Fully tighten the bolt (rear).

      80 N*m

      816 kgf*cm

      59 ft.*lbf

      Note:

      Since a stopper nut is used, fully tighten the bolt.

   2. Fully tighten the 2 bolts (front).

      85 N*m

      867 kgf*cm

      63 ft.*lbf

4. Click here

   CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

   
   

   1. Connect the No. 3 parking brake cable assembly with the bolt.

      6.0 N*m

      61 kgf*cm

      53 in.*lbf

5. Click here

   INSTALL NO. 2 FLOOR UNDER COVER

   Click here

6. Click here

   INSTALL NO. 1 FLOOR UNDER COVER (for RH Side)

   Click here

7. Click here

   INSTALL REAR WHEEL

   103 N*m

   1049 kgf*cm

   76 ft.*lbf