Click here

FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

Click here
Click here Click here

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

Click here

PROCEDURE


  1. Click here

    INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A000941E05

      Engage the guide to temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.

    2. Fully tighten the bolt <A> first, then the bolt <B> to install the front shoulder belt anchor adjuster assembly.

      42 N*m 428 kgf*cm 31 ft.*lbf
  2. Click here

    INSPECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  3. Click here

    INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. A0003R3E05

      Install the bolt <A> first, then the bolt <B> to temporarily install the front seat outer belt assembly.

    2. Fully tighten the 2 bolts.

      Bolt <A>
      7.5 N*m 76 kgf*cm 66 in.*lbf
      Bolt <B>
      42 N*m 428 kgf*cm 31 ft.*lbf

    3. Connect the connector.

    4. A000822E05

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Table 1. Text in Illustration
      *a Pretensioner Connector
      Note:

      Securely lock the locking button.

    5. Connect the shoulder anchor of the front seat outer belt assembly with the nut.

      42 N*m 428 kgf*cm 31 ft.*lbf
  4. Click here

    INSTALL CENTER PILLAR UPPER GARNISH

    Click here

  5. Click here

    INSTALL CENTER PILLAR LOWER GARNISH

    Click here

  6. Click here

    INSTALL REAR DOOR SCUFF PLATE

    Click here

  7. Click here

    INSTALL FRONT DOOR SCUFF PLATE

    Click here

  8. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  9. Click here

    CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. Operate the power seat switch assembly and move the front seat assembly so that the nut for the anchor of the front seat outer belt assembly can be installed.

    2. A00090NE01

      Connect the anchor of the front seat outer belt assembly with the nut.

      Table 2. Text in Illustration
      *1 Protruding Part
      42 N*m 428 kgf*cm 31 ft.*lbf
      Note:

      • Install the front seat outer belt assembly with the arrow on the anchor part facing the front of the vehicle.

      • Do not allow the anchor part of the front seat outer belt assembly to overlap the protruding parts of the front seat assembly.

  10. Click here

    INSTALL SEAT BELT ANCHOR COVER CAP


    1. A0008R0

      Engage the 6 guides and install the seat belt anchor cover cap.

  11. Click here

    INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  12. Click here

    INSPECT SRS WARNING LIGHT

    (Click here)