FRONT SEAT OUTER BELT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY


    1. A000941E05

      Engage the guide to temporarily install the front shoulder belt anchor adjuster assembly with the 2 bolts.

    2. Fully tighten the bolt <A> first, then the bolt <B> to install the front shoulder belt anchor adjuster assembly.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  2. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (w/o Pre-crash Safety System)

    Click here

  3. INSPECT FRONT SEAT OUTER BELT ASSEMBLY (w/ Pre-crash Safety System)

    Click here

  4. INSTALL FRONT SEAT OUTER BELT ASSEMBLY


    1. A00087JE02

      Install the bolt <A> first, then the bolt <B> to temporarily install the front seat outer belt assembly.

    2. Fully tighten the 2 bolts.

      Torque:
      Bolt <A>
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }
      Bolt <B>
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

    3. w/o Pre-crash Safety System:


      1. Connect the connector.

    4. w/ Pre-crash Safety System:


      1. Connect the 2 connectors.

    5. A0009MJE02
      Text in Illustration
      *1 Pretensioner Connector
      *2 Pre-crash Safety Connector

      Connect the pretensioner connector and lock the locking button as shown in the illustration.

      Note

      Securely lock the locking button.

    6. Connect the shoulder anchor of the front seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

  5. INSTALL CENTER PILLAR UPPER GARNISH

    Click here

  6. INSTALL CENTER PILLAR LOWER GARNISH

    Click here

  7. INSTALL REAR DOOR SCUFF PLATE

    Click here

  8. INSTALL FRONT DOOR SCUFF PLATE

    Click here

  9. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  10. CONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. Operate the power seat switch assembly and move the front seat assembly so that the nut for the anchor of the front seat outer belt assembly can be installed.

    2. A00090NE01
      Text in Illustration
      *1 Protruding Part

      Connect the anchor of the front seat outer belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note


      • Install the front seat outer belt assembly with the arrow on the anchor part facing the front of the vehicle.

      • Do not allow the anchor part of the front seat outer belt assembly to overlap the protruding parts of the front seat assembly.

  11. INSTALL SEAT BELT ANCHOR COVER CAP


    1. A0008R0

      Engage the 6 guides and install the seat belt anchor cover cap.

  12. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  13. INSPECT SRS WARNING LIGHT

    Click here