SEAT BELT WARNING SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter or SRS Airbag / Data List.

    5. Read the Data List according to the display on the GTS.

      Combination Meter
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      P-Seatbelt Buckle SW Front passenger seat belt buckle switch signal/ON or OFF

      ON: Front passenger seat belt unfastened

      OFF: Front passenger seat belt fastened

      		 The front passenger seat is occupied
      Driver Side Seatbelt Warning Buzzer Driver seat belt warning buzzer/ON or OFF Customized value displayed -
      P-Seatbelt Warning Buzzer Front passenger seat belt warning buzzer/ON or OFF Customized value displayed -
      SRS Airbag
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      Left side Buckle SW LH buckle switch/Unset, Set or NG

      Unset: Seat belt not fastened

      Set: Seat belt fastened

      NG: Data is not determined

      		 -

  2. ACTIVE TEST

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Combination Meter / Active Test.

    5. Perform the Active Test according to the display on the GTS.

      Combination Meter
      Tester Display Test Part Control Range Diagnostic Note
      Driver Side Seat Belt Seat belt warning light OFF/ON -