SEAT HEATER CONTROL(for Rear Side) REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. REMOVE REAR SEAT HEADREST ASSEMBLY

  5. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY

  6. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  7. REMOVE REAR SEATBACK ASSEMBLY

    Click here

  8. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY

    Tech Tips

    Use the same procedure for the RH side and the LH side.


    1. A00048R

      Disconnect the connector.

    2. Remove the 2 screws and seat heater control subassembly.