SEAT HEATER SWITCH(for Rear Side) REMOVAL

PROCEDURE

1. PRECAUTION

   CAUTION:

   Be sure to read Precaution thoroughly before servicing Click here.

   Note

   After turning the power switch off, waiting time may be required before disconnecting the cable from the auxiliary battery negative (-) terminal. Therefore, make sure to read the disconnecting the cable from the auxiliary battery negative (-) terminal notices before proceeding with work Click here.

2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

   Click here

3. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

   CAUTION:

   Wait at least 90 seconds after disconnecting the cable from the auxiliary battery negative (-) terminal to disable the SRS system.

   Note

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

4. REMOVE REAR SEAT HEADREST ASSEMBLY

5. REMOVE REAR CENTER SEAT HEADREST ASSEMBLY

6. REMOVE REAR SEAT CUSHION ASSEMBLY

   Click here

7. REMOVE REAR SEATBACK ASSEMBLY

   Click here

8. REMOVE REAR CENTER SEAT ARMREST ASSEMBLY WITH BOX

   Click here

9. REMOVE REAR CENTER SEAT ARMREST HINGE

   Click here

10. REMOVE REAR CENTER SEAT ARMREST ASSEMBLY

    Click here

11. REMOVE REAR CENTER SEAT ARMREST DOOR SUB-ASSEMBLY

    Click here

12. REMOVE REAR CENTER SEAT ARMREST PANEL SUB-ASSEMBLY

    Click here

13. REMOVE COOLER CONTROL SWITCH ASSEMBLY

    
    

    1. 

       Disconnect the 2 connectors.

    2. 

       Disengage the 4 claws and remove the cooler control switch assembly.