POWER SEAT SWITCH(for Front Passenger Side) INSPECTION

PROCEDURE

1. Click here

   INSPECT POWER SEAT SWITCH ASSEMBLY

   
   

   1. Measure the resistance according to the value(s) in the table below.

      
      
      1. 

         for LHD

         Standard Resistance
         Table 1. Reclining Switch Tester Connection Condition Specified Condition 3 - 4 Front Below 1 Ω 3 - 4 Off 10 kΩ or higher 3 - 5 3 - 5 Rear Below 1 Ω
         Table 2. Slide Switch Tester Connection Condition Specified Condition 2 - 3 Front Below 1 Ω 2 - 3 Off 10 kΩ or higher 1 - 3 1 - 3 Rear Below 1 Ω

         Table 3. Text in Illustration

         *1	Reclining Switch
         *2	Slide Switch
         *3	Front
         *4	Rear
         *a	Component without harness connected (Power Seat Switch Assembly)

         If the result is not as specified, replace the power seat switch assembly.

      2. 

         for RHD

         Standard Resistance
         Table 4. Reclining Switch Tester Connection Condition Specified Condition 2 - 3 Front Below 1 Ω 2 - 3 Off 10 kΩ or higher 3 - 1 3 - 1 Rear Below 1 Ω
         Table 5. Slide Switch Tester Connection Condition Specified Condition 3 - 4 Front Below 1 Ω 3 - 4 Off 10 kΩ or higher 3 - 5 3 - 5 Rear Below 1 Ω

         Table 6. Text in Illustration

         *1	Reclining Switch
         *2	Slide Switch
         *3	Front
         *4	Rear
         *a	Component without harness connected (Power Seat Switch Assembly)

         If the result is not as specified, replace the power seat switch assembly.