Click here

REAR SEAT ASSEMBLY INSTALLATION

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL REAR SEATBACK ASSEMBLY


    1. Place the rear seatback assembly in the cabin.

      Note:

      Be careful not to damage the vehicle body.

    2. Engage the 3 hooks.

    3. Connect the rear seat 3 point type outer belt assembly LH, rear seat 3 point type outer belt assembly RH and rear seat inner with center belt assembly LH to the rear seatback assembly.

    4. Install the rear seatback assembly with the 4 bolts.

      18 N*m 184 kgf*cm 13 ft.*lbf

    5. Engage the 2 clamps to connect the 2 rear seat airbag assembly wire harnesses.

    6. Connect the 2 rear seat airbag assembly connectors.

    7. A0007AL

      Engage the claw to connect the rear center seat shoulder belt guide.

    8. A0004IE

      Engage the claw to connect the rear seat shoulder belt guide RH.

    9. A0004SH

      Engage the claw to connect the rear seat shoulder belt guide LH.

  2. Click here

    INSTALL REAR SEAT CUSHION LOCK HOOK


    1. A0005WX

      Engage the 2 claws to install the rear seat cushion lock hook.

      Tip:

      Use the same procedure for the RH side and the LH side.

  3. Click here

    INSTALL REAR SEAT CUSHION ASSEMBLY


    1. Place the rear seat cushion assembly in the cabin.

      Note:

      Be careful not to damage the vehicle body.

    2. w/ Climate Control Seat System:


      1. Connect the rear seat heater connector.

    3. Pass the buckle of the rear seat inner with center belt assembly LH and buckle of the rear seat inner with center belt assembly RH through the rear seat cushion assembly.

    4. A00044BE06

      Engage the 2 hooks <B> on rear side of the rear seat cushion assembly to the rear seatback hinge hook.

      Table 1. Text in Illustration
      *1 Rear Seatback Hinge Hook

    5. Engage the 2 hooks <A> on the front side of the rear seat cushion assembly to the vehicle body as shown in the illustration.

    6. Confirm that the rear seat cushion assembly is securely installed.

      Note:

      When installing the rear seat cushion assembly, make sure that the seat belt buckles are not under the rear seat cushion assembly.

  4. Click here

    INSTALL REAR CENTER SEAT HEADREST ASSEMBLY

  5. Click here

    INSTALL REAR SEAT HEADREST ASSEMBLY

  6. Click here

    CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  7. Click here

    INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  8. Click here

    INSPECT SRS WARNING LIGHT

    (Click here)