FRONT SEAT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. Click here

   INSTALL FRONT SEAT ASSEMBLY

   
   

   1. Place the front seat assembly in the cabin.

      Note:

      Be careful not to damage the vehicle body.

   2. Connect each connector and engage each clamp under the seat.

   3. Connect the cable to the negative (-) auxiliary battery terminal.

      Note:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

   4. Temporarily install the front seat assembly with the 4 bolts.

   5. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

   6. 

      Tighten the 2 bolts on the front side of the seat.

      37 N*m

      377 kgf*cm

      27 ft.*lbf

      Note:

      Tighten the bolts in the order indicated in the illustration.

   7. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.

   8. 

      Tighten the 2 bolts on the rear side of the seat.

      37 N*m

      377 kgf*cm

      27 ft.*lbf

      Note:

      Tighten the bolts in the order indicated in the illustration.

2. Click here

   INSTALL REAR INNER SEAT TRACK BRACKET COVER

   
   

   1. Engage the 2 claws to install the rear inner seat track bracket cover.

3. Click here

   INSTALL REAR OUTER SEAT TRACK BRACKET COVER

   
   

   1. Engage the 2 claws to install the rear outer seat track bracket cover.

4. Click here

   INSTALL FRONT INNER SEAT TRACK BRACKET COVER

   
   

   1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

   2. Engage the 2 claws to install the front inner seat track bracket cover.

5. Click here

   INSTALL FRONT OUTER SEAT TRACK BRACKET COVER

   
   

   1. Engage the 2 claws to install the front outer seat track bracket cover.

6. Click here

   CONNECT FRONT SEAT OUTER BELT ASSEMBLY

   Click here

7. Click here

   INSTALL SEAT BELT ANCHOR COVER CAP

   Click here

8. Click here

   INSTALL FRONT SEAT HEADREST ASSEMBLY

9. Click here

   INSPECT FRONT SEAT ASSEMBLY

   
   

   1. Check power seat operation.

      w/o Memory: (Click here)

      w/ Memory: (Click here)

   2. w/ Seat Heater System:

      Check seat heater operation.

      
      

      1. Turn the power switch on (IG).

      2. Turn the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

10. Click here

    INSPECT SRS WARNING LIGHT

    (Click here)

11. Click here

    INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here