FRONT SEAT ASSEMBLY INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL FRONT SEAT ASSEMBLY


    1. Place the front seat assembly in the cabin.

      Note

      Be careful not to damage the vehicle body.

    2. Connect each connector and engage each clamp under the seat.

    3. Connect the cable to the negative (-) auxiliary battery terminal.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    4. Temporarily install the front seat assembly with the 4 bolts.

    5. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    6. A0009JGE04

      Tighten the 2 bolts on the front side of the seat.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Tighten the bolts in the order indicated in the illustration.

    7. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.

    8. A00065NE01

      Tighten the 2 bolts on the rear side of the seat.

      Torque:
      37 N*m  { 377 kgf*cm, 27 ft.*lbf }

      Note

      Tighten the bolts in the order indicated in the illustration.

  2. INSTALL REAR INNER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the rear inner seat track bracket cover.

  3. INSTALL REAR OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the rear outer seat track bracket cover.

  4. INSTALL FRONT INNER SEAT TRACK BRACKET COVER


    1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    2. Engage the 2 claws to install the front inner seat track bracket cover.

  5. INSTALL FRONT OUTER SEAT TRACK BRACKET COVER


    1. Engage the 2 claws to install the front outer seat track bracket cover.

  6. CONNECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  7. INSTALL SEAT BELT ANCHOR COVER CAP

    Click here

  8. INSTALL FRONT SEAT HEADREST ASSEMBLY

  9. INSPECT FRONT SEAT ASSEMBLY


    1. Check power seat operation.

      w/o Memory: Click here

      w/ Memory: Click here

    2. w/ Seat Heater System:

      Check seat heater operation.


      1. Turn the power switch on (IG).

      2. Turn the seat heater switch on.

      3. Wait 5 minutes or more and confirm that the seat surface becomes warm.

  10. INSPECT SRS WARNING LIGHT

    Click here

  11. INSTALL LUGGAGE TRIM SERVICE HOLE COVER

    Click here