FRONT SEAT ASSEMBLY REMOVAL

PROCEDURE


  1. PRECAUTION

    CAUTION:


    • Be sure to read Precaution thoroughly before servicing Click here.

    • If the side airbag has deployed, replace the front seat airbag assembly, front seatback frame sub-assembly, separate type front seatback pad and separate type front seatback cover with the necessary parts in accordance with the extent of the collision damage.

    Note


    • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work Click here.

    Tech Tips


    • Use the same procedure for the RH side and LH side.

    • The following procedure is for the LH side.

  2. REMOVE LUGGAGE TRIM SERVICE HOLE COVER

    Click here

  3. REMOVE FRONT SEAT HEADREST ASSEMBLY

  4. REMOVE SEAT BELT ANCHOR COVER CAP

    Click here

  5. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  6. REMOVE REAR OUTER SEAT TRACK BRACKET COVER


    1. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.

    2. A00058G

      Disengage the 2 claws to remove the rear outer seat track bracket cover.

  7. REMOVE REAR INNER SEAT TRACK BRACKET COVER


    1. A0003F8

      Disengage the 2 claws to remove the rear inner seat track bracket cover.

  8. REMOVE FRONT OUTER SEAT TRACK BRACKET COVER


    1. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    2. A00049J

      Disengage the 2 claws to remove the front outer seat track bracket cover.

  9. REMOVE FRONT INNER SEAT TRACK BRACKET COVER


    1. A0006KT

      Disengage the 2 claws to remove the front inner seat track bracket cover.

  10. REMOVE FRONT SEAT ASSEMBLY


    1. Operate the slide and vertical power seat switch knob and move the seat to the foremost position.

    2. A00065N

      Remove the 2 bolts on the rear side of the seat.

    3. Operate the slide and vertical power seat switch knob and move the seat to the rearmost position.

    4. A0009JG

      Remove the 2 bolts on the front side of the seat.

    5. Operate the slide and vertical power seat switch knob and move the seat to the uppermost position.

    6. Operate the slide and vertical power seat switch knob and move the seat to the center position.

    7. Operate the reclining power seat switch knob and move the seatback to the upright position.

    8. for Driver Side:


      1. Operate the seat variable cushion switch and raise the leg rest part of the separate type front seat cushion cover with pad to the uppermost position.

    9. Disconnect the cable from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      Note

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

    10. Disconnect each connector and disengage each clamp under the seat.

    11. Remove the front seat assembly.

      Note

      Be careful not to damage the vehicle body.