Click here

PRE-CRASH SAFETY SYSTEM, Diagnostic DTC:C1A10

Click here
Click here
DTC Code DTC Name
C1A10 Front Radar Sensor
Click here

DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor assembly to detect obstacles in front of the vehicle.

Based on this information, the driving support ECU assembly sends pre-crash control operation signals.

When the driving support ECU assembly receives information that there is a malfunction in the millimeter wave radar sensor assembly, DTC C1A10 is stored.

DTC No. DTC Detection Condition Trouble Area
C1A10 When the power switch is on (IG), the driving support ECU assembly receives information that there is a malfunction in the millimeter wave radar sensor assembly for approximately 0.2 seconds.

  • Millimeter wave radar sensor assembly

  • Driving support ECU assembly
Click here

CAUTION / NOTICE / HINT

Note:

  • When replacing the driving support ECU assembly, always replace it with a new one. If a driving support ECU assembly which was installed to another vehicle is used, the information stored in the driving support ECU assembly will not match the information from the vehicle. As a result, a DTC may be stored.

  • When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed (Click here).

  • First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting (Click here).

Click here

PROCEDURE


  1. Click here

    REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. Replace the millimeter wave radar sensor assembly (Click here).


  2. Click here

    ADJUST MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. Adjust the millimeter wave radar sensor assembly (Click here).


  3. Click here

    CHECK DTC OUTPUT (PRE-CRASH SAFETY SYSTEM)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Turn the GTS on.

    4. Enter the following menus: Body Electrical / Pre-Crash 2 / Trouble Codes.

    5. Clear the DTCs (Click here).

    6. Make sure that the DTC detection conditions are met.

      Tip:

      If the detection conditions are not met, the system cannot detect the malfunction.

    7. Check for DTCs (Click here).

      Table 1. Result
      Result Proceed to
      DTC C1A10 is not output A
      DTC C1A10 is output B

    • A

      END (MILLIMETER WAVE RADAR SENSOR ASSEMBLY WAS DEFECTIVE)

    • B

      REPLACE DRIVING SUPPORT ECU ASSEMBLY (Click here)