Click here

COOLER EXPANSION VALVE INSTALLATION

Click here
Click here

CAUTION / NOTICE / HINT

Click here

PROCEDURE


  1. Click here

    INSTALL COOLER EXPANSION VALVE


    1. Apply sufficient compressor oil to 2 new O-rings and the fitting surfaces of the cooler expansion valve.

      Compressor oil
      ND-OIL 11 or equivalent

    2. Install the 2 new O-rings to the No. 1 cooler evaporator sub-assembly.

    3. Using a 4 mm hexagon wrench, install the new cooler expansion valve with the 2 hexagon bolts.

      3.5 N*m 36 kgf*cm 31 in.*lbf
  2. Click here

    CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY

    Click here

  3. Click here

    CONNECT SUCTION PIPE SUB-ASSEMBLY


    1. Remove the vinyl tape from the suction pipe sub-assembly.

    2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction pipe sub-assembly.

      Compressor oil
      ND-OIL 11 or equivalent

    3. Install the O-ring to the suction pipe sub-assembly.

    4. Connect the suction pipe sub-assembly.

    5. A0003JE

      Rotate the hook connector in the direction indicated by the arrow in the illustration.

    6. Insert the pipe joint into the fitting hole securely and tighten a new bolt.

      9.8 N*m 100 kgf*cm 87 in.*lbf
  4. Click here

    CONNECT NO. 1 BRAKE ACTUATOR TUBE

    Click here

  5. Click here

    INSTALL FRONT OUTER COWL TOP PANEL SUB-ASSEMBLY

    for LHD: (Click here)

    for RHD: (Click here)

  6. Click here

    INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    (Click here)

  7. Click here

    CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

    Click here

  8. Click here

    WARM UP COMPRESSOR

    Click here

  9. Click here

    INSPECT FOR REFRIGERANT LEAK

    Click here