ГЕНЕРАТОР (для моделей с номинальным током 100 A) УСТАНОВКА


  1. INSTALL GENERATOR ASSEMBLY


    1. Install the generator with the 3 bolts.

      Torque:
      25 N*m  { 255 kgf*cm, 18 ft.*lbf }

      Note

      Make sure that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and generator when installing the generator.

    2. Attach the wire clamp.

    3. Connect the generator wire with the nut and bolt.

      Torque:
      for nut
      9.8 N*m  { 100 kgf*cm, 87 in.*lbf }
      for bolt
      8.4 N*m  { 85 kgf*cm, 74 in.*lbf }

    4. Connect the generator connector and attach the clamp.

    5. Install the terminal cap.

  2. INSTALL FAN AND GENERATOR V BELT


    1. Using SST and a 22 mm wrench, rotate the tensioner pulley counterclockwise, and then install the fan and generator V belt.

      SST
      09216-42010

      CAUTION:


      • Be careful as the wrench only fits loosely on the belt tensioner tool set point. The wrench may come off the set point and cause injuries.

      • Be careful that your hands do not become jammed between parts such as the belt, pulleys, etc.

      Note


      • Make sure that the belt is set properly on each pulley.

      • Make sure SST is installed as shown in the illustration. If not, SST and/or the belt may not be able to be removed.

      A01ISZME01

  3. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT RH


    1. A01INC5E01

      Установите правое усиление элемента передней подвески и закрепите его 4 болтами.

      Torque:
      99 Н*м  { 1010 кгс*см, 73 фунт-сила-фута }

      Note

      Затягивайте болты в порядке, указанном на рисунке.

  4. INSTALL REAR ENGINE UNDER COVER RH


    1. Закрепите защиту картера 5 фиксаторами.

  5. INSTALL NO. 1 ENGINE UNDER COVER


    1. A01IRQL

      Установите защиту картера двигателя № 1 и закрепите ее 10 фиксаторами и 6 болтами.

  6. INSTALL RADIATOR SUPPORT OPENING COVER


    1. Install the radiator support opening cover with the 5 clips.

  7. INSTALL NO. 1 ENGINE COVER


    1. Attach the 4 clips to install the No. 1 engine cover.

  8. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  9. INSTALL BATTERY SERVICE HOLE COVER


    1. Install the battery service hole cover with the clip.

  10. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

    Click here