ПЕРЕДНИЙ ПРИВОДНОЙ ВАЛ В СБОРЕ (для моделей с 1AD-FTV, 2AD-FHV) УСТАНОВКА


  1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH


    1. Coat the spline of the inboard joint shaft with oil.

      Tech Tips

      Be sure to use the same type of oil that is used for the transaxle.

    2. A01ITI9

      Align the shaft splines and tap in the drive shaft with a brass bar and hammer.

      Note


      • Make sure that the snap ring opening is facing downwards when installing the drive shaft.

      • Be careful not to damage the oil seal, boot or dust cover.

  2. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH


    1. Coat the spline of the inboard joint shaft with gear oil.

    2. A01IR8P

      Align the shaft splines and securely insert the drive shaft.

    3. Install the 2 bearing bracket bolts.

      Torque:
      64 N*m  { 650 kgf*cm, 47 ft.*lbf }

      Note

      Do not damage the oil seal, boot or dust cover.

  3. INSTALL NO. 1 ENGINE UNDER COVER


    1. A01IRQL

      Install the No. 1 engine under cover with the 10 clips and 6 bolts.

  4. CLEAN DRIVE SHAFT AND AXLE SHAFT NUT


    1. Clean the threaded parts on the drive shaft and a new axle shaft nut using a non-residue solvent.

      Note


      • Be sure to perform this work for a new drive shaft.

      • Keep the threaded parts free of oil and foreign objects.

  5. INSTALL FRONT AXLE ASSEMBLY LH


    1. Install the front axle assembly LH Click here.

  6. INSTALL FRONT AXLE ASSEMBLY RH

    Tech Tips

    Use the same procedures described for the LH side.