РАБОЧИЙ ЦИЛИНДР СЦЕПЛЕНИЯ (для моделей с 1AD-FTV, 2AD-FHV) СНЯТИЕ


  1. REMOVE BATTERY SERVICE HOLE COVER


    1. A01ITOM

      Снимите фиксатор и крышку технологического отверстия аккумуляторной батареи.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  5. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IRWC

      Освободите 5 фиксаторов и снимите крышку кронштейна радиатора.

  6. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A01IP71

      Remove the bolt and loosen the nut.

    2. Detach the hook of the battery clamp from the battery carrier, and then remove the battery clamp.

  7. REMOVE BATTERY INSULATOR

  8. REMOVE BATTERY

  9. REMOVE BATTERY TRAY

  10. DISCONNECT CLUTCH RELEASE CYLINDER TO ACCUMULATOR TUBE


    1. A01IRA8

      Using a union nut wrench, disconnect the clutch release cylinder to accumulator tube.

      Tech Tips

      Use a container to catch the fluid.

  11. REMOVE CLUTCH RELEASE CYLINDER ASSEMBLY


    1. A01IR3U

      Remove the 3 bolts, clutch release cylinder assembly and No. 1 clutch tube bracket.

  12. REMOVE RELEASE CYLINDER BLEEDER PLUG


    1. Remove the boot from the cylinder body.

    2. A01IRG0E01

      Remove the release cylinder bleeder plug from the cylinder body.

  13. REMOVE CLUTCH RELEASE CYLINDER KIT


    1. Remove the push rod from the cylinder body.

    2. A01IPG2

      Using compressed air, remove the piston and spring from the cylinder body.

    3. Remove the bleeder plug cap from the bleeder plug.

      Note

      Do not damage the inside of the cylinder body.