ГИДРОАККУМУЛЯТОР ПРИВОДА СЦЕПЛЕНИЯ (для моделей с 1AD-FTV, 2AD-FHV) СНЯТИЕ


  1. REMOVE BATTERY SERVICE HOLE COVER


    1. A01ITOM

      Снимите фиксатор и крышку технологического отверстия аккумуляторной батареи.

  2. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  5. REMOVE FRONT LOWER BUMPER ABSORBER


    1. A01IOQE

      Снимите 2 фиксатора.

    2. A01IPJ8

      Отверните 4 болта.

    3. Отцепите 2 зацепа переднего нижнего поглотителя энергии удара от установочных отверстий в кузове и снимите передний нижний поглотитель энергии удара.

  6. REMOVE NO. 1 ENGINE UNDER COVER


    1. A01IRQL

      Выверните 6 болтов и снимите 10 фиксаторов.

    2. Снимите нижнюю крышку двигателя № 1.

  7. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IRWC

      Освободите 5 фиксаторов и снимите крышку кронштейна радиатора.

  8. REMOVE BATTERY CLAMP SUB-ASSEMBLY


    1. A01IP71

      Remove the bolt and loosen the nut.

    2. Detach the hook of the battery clamp from the battery carrier, and then remove the battery clamp.

  9. REMOVE BATTERY INSULATOR

  10. REMOVE BATTERY

  11. REMOVE BATTERY TRAY

  12. REMOVE BATTERY CARRIER


    1. A01ISD1

      Detach the 2 clamps and disconnect the wire harness.

    2. Remove the 4 bolts and battery carrier.

  13. REMOVE CLUTCH ACCUMULATOR ASSEMBLY

    A01IRYT

    1. Using a union nut wrench, separate the clutch release cylinder to accumulator tube from the clutch accumulator assembly.

      Tech Tips

      Use a container to catch the fluid.

    2. Using a union nut wrench, disconnect the accumulator to flexible hose tube from the clutch accumulator assembly and flexible hose.

      Tech Tips

      Use a container to catch the fluid.

    3. Remove the bolt and accumulator to flexible hose tube from the clutch accumulator assembly.

    4. Remove the clip and separate the flexible hose from the clutch accumulator assembly.

    5. A01IQ2P

      Remove the 3 bolts and clutch accumulator assembly.