TCM СНЯТИЕ


  1. REMOVE BATTERY SERVICE HOLE COVER


    1. A01ITOM

      Снимите фиксатор и крышку технологического отверстия аккумуляторной батареи.

  2. REMOVE RADIATOR SUPPORT OPENING COVER


    1. A01IRWC

      Освободите 5 фиксаторов и снимите крышку кронштейна радиатора.

  3. REMOVE REAR ENGINE UNDER COVER LH


    1. A01INGO

      Снимите 5 фиксаторов и защиту картера.

  4. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  5. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  6. REMOVE BATTERY


    1. Disconnect the cable from the positive (+) battery terminal.

    2. Remove the bolt and loosen the nut.

    3. Remove the battery clamp.

    4. Remove the battery.

    5. Remove the battery tray.

  7. REMOVE BATTERY CARRIER


    1. A01ISD1

      Detach the 2 clamps and disconnect the wire harness.

    2. Remove the 4 bolts and battery carrier.

  8. REMOVE TCM

    A01ISV7E01

    1. Detach the claw, turn the lock lever and disconnect the connector from the TCM.

    2. A01ISIM

      Remove the 2 bolts and pull up the TCM from the transaxle to remove it.