ДАТЧИК ТЕМПЕРАТУРЫ ТРАНСМИССИОННОЙ ЖИДКОСТИ УСТАНОВКА


  1. INSTALL ATF TEMPERATURE SENSOR ASSEMBLY

    A01IPSFE03
    Text in Illustration
    *1 New O-ring

    1. Coat a new O-ring with ATF and install it to the ATF temperature sensor.

    2. Coat the 4 bolts with ATF.

    3. A01IT9HE08
      Text in Illustration
      *1 Clamp

      Install the ATF temperature sensor and clamp to the valve body with the 4 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

      Tech Tips

      Each bolt length is indicated below.

      Bolt A: 25 mm (0.984 in.)

      Bolt B: 85 mm (3.35 in.)

    4. Connect the connector.

  2. INSTALL VALVE BODY OIL STRAINER ASSEMBLY

    A01IQS1

    1. Coat a new O-ring with ATF and install it to the oil strainer.

      Note

      Ensure that the O-ring is not twisted or pinched.

    2. A01IT74

      Install the oil strainer to the valve body with the 2 bolts.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }

  3. INSTALL AUTOMATIC TRANSAXLE OIL PAN SUB-ASSEMBLY

    A01IP69E05

    1. Install the 2 magnets to the oil pan.

      Text in Illustration
      *1 Magnet

    2. Install a new gasket to the oil pan.

    3. A01IQ7UE01

      Apply seal packing to the bolt labeled A in the illustration.

      Seal packing
      Toyota Genuine Seal Packing 1281,
      Three Bond 1281 or equivalent

    4. Install the oil pan to the automatic transaxle with the 18 bolts.

      Torque:
      for bolt labeled A
      7.0 N*m  { 71 kgf*cm, 62 in.*lbf }
      for other bolts
      7.5 N*m  { 76 kgf*cm, 66 in.*lbf }

      Note


      • In order to ensure proper sealing of the transmission oil pan bolt, apply seal packing to the bolt and install it within 10 minutes of seal packing application.

      • Completely remove any oil or grease from the contact surfaces of the transaxle case, oil pan sub-assembly and gasket before installation.

  4. INSTALL FRONT SUSPENSION MEMBER REINFORCEMENT LH

    A01IRC7

    1. Install the front suspension member reinforcement with the 4 bolts.

      Torque:
      99 N*m  { 1010 kgf*cm, 73 ft.*lbf }

  5. ADD AUTOMATIC TRANSAXLE FLUID


    1. Add automatic transaxle fluid Click here.

  6. INSTALL REAR ENGINE UNDER COVER LH


    1. Закрепите защиту картера 5 фиксаторами.

  7. INSTALL NO. 1 ENGINE UNDER COVER


    1. A01IRQL

      Install the No. 1 engine under cover with the 10 clips and 6 bolts.